GE ProCare Error Codes

28 codes from pages 61–80 of the manual

This is the list of alarm codes the GE manual gives for the ProCare ProCare Monitor. Find your code below and open it for what the manual says about its causes and what to do.

Alarm codes from p. 61

CodeWhat it meansPage
E89 BP NO DETERMINATION p. 80
E85 BP LEVEL TIMEOUT p. 80
E84 BP TOTAL TIMEOUT p. 80
E83 BP INFLATION TIMEOUT p. 80
E82 EXCESS AIR IN CUFF p. 80
E80 BP OVERPRESSURE p. 80
E21 SPO2 REPLACE SENSOR p. 61
E22 SPO2 REPOSITION SENSOR (Masimo ONLY) p. 61
E23 SPO2 SENSOR OFF FINGER p. 61
E25 SPO2 NO SIGNAL p. 61
E61 TEMP PROBE BROKEN p. 61
E63 TEMP DISCONNECTED OR WRONG TYPE PROBE p. 61
E66 TEMP PROBE TOO HOT p. 61
E10 PRINTER NO PAPER p. 61
E11 PRINTER TOO HOT p. 61
E12 BATTERY TOO LOW TO PRINT p. 61
E13 BATTERY TOO LOW TO OPERATE p. 61
930 SpO2 no status from module for 30 ±10s, fatal error reported by module p. 62
940 TEMP data samples less than 45 in 5s interval p. 62
950 NIBP pump on during idle or overcurrent detected p. 62
951 NIBP valve stuck closed during cuff typing p. 62
952 NIBP PT2 higher than 150 for greater than 15s while idle p. 62
970 Time base failure p. 62
971 RAM test failure p. 62
972 ROM checksum failure p. 62
973 Secondary SPI communication error during initialization p. 62
974 Calibration data invalid on initialization or unit never calibrated p. 62
975 Calibration data storage exhausted while saving data in cal mode p. 62

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with GE. Found a mistake? Report an error.