Fuji Electric FRENIC-Eco Error E-6: Operation error detection

FRENIC-Eco inverter · taken from the manufacturer’s manual, pages cited

Error codeE-6

The inverter detected an operation error due to a STOP key being pressed. The manual lists no action for this code.

Model: Fuji Electric FRENIC-Eco
Display shows: Operation error detection (E-6)
Type: Error code
Source: Manual p. 207

Meaning
Common causes
Still not solved
Source

What E-6 means

Operation error detection p. 207

Common causes

STOP key priority: Pressing the key on the keypad forces the inverter to decelerate and stop the motor even if the inverter is running by any run commands given via the terminals or communications (link operation). After the motor stops, the inverter issues alarm E-6. p. 207

If E-6 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Fuji Electric service.

Open the manual at page 207 All FRENIC-Eco error codes Manual details & download

This page summarises what the manufacturer’s manual says about E-6; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Fuji Electric. Found a mistake? Report an error.