FANUC R-30+A/R-30+A Mate/R-30+B Error PRIO-358: EtherNet/IP Fwd Open Fail (0x#)

FANUC R-30+A/R-30+A Mate/R-30+B · taken from the manufacturer’s manual, pages cited

Error codePRIO-358

EtherNet/IP Forward Open Fail (0x#) indicates a communication failure in the forward direction. The manual lists no action for this code.

Model
FANUC R-30+A/R-30+A Mate/R-30+B
Display shows
EtherNet/IP Fwd Open Fail (0x#) (PRIO-358)
Type
Error code
Source
Manual p. 106

What PRIO-358 means

EtherNet/IP Fwd Open Fail (0x#) p. 106

Safety warnings — read before you start

  • WARNINGWARNING. Applied when there is a danger of the user being injured or when there is a danger of both the user being injured and the equipment being damaged if the approved procedure is not observed. p. 4

If PRIO-358 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact FANUC service.

Open the manual at page 106 All R-30+A/R-30+A Mate/R-30+B error codes Manual details & download

This page summarises what the manufacturer’s manual says about PRIO-358; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FANUC. Found a mistake? Report an error.