A parameter change has not been fully entered into the system due to power interruption during configuration. The manual's first action is: “Enter configuration mode then return to the required operating mode. It may be necessary to re-enter the parameter change since it will not have been entered in the previous configuration.”
- Model
- Eurotherm 3116, 3216
- Display shows
- EConf
- Type
- Error code
- Source
- Manual p. 62
What EConf means
A change made to a parameter takes a finite time to be entered. If the power to the controller is turned off before the change has been entered then this alarm will occur. p. 62
Common causes
- A change made to a parameter takes a finite time to be entered. If the power to the controller is turned off before the change has been entered then this alarm will occur. p. 62
- Do not turn the power off to the controller while EConf is flashing p. 62
What to do
- Enter configuration mode then return to the required operating mode. It may be necessary to re-enter the parameter change since it will not have been entered in the previous configuration. p. 62
Before you service the product, read the safety instructions in the manual p. 23.
If EConf is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Eurotherm service.
This page summarises what the manufacturer’s manual says about EConf; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Eurotherm. Found a mistake? Report an error.