Eurotherm 2216e Error Codes: List of 21 Codes and Their Meaning

This is the list of fault, error, alarm codes the Eurotherm manual gives for the 2216e Eurotherm 2216e controller. Find your code below and open it for what the manual says about its causes and what to do.

Fault codes from p. 21

Code	What it means	Page
`EEEr`	Electrically Erasable Memory Error:	p. 21
`S.br`	Sensor Break:	p. 21
`L.br`	Loop Break:	p. 21
`l.dF`	Load failure	p. 21
`5Sr.F`	Solid state relay failure	p. 21
`Hr.F`	Heater failure	p. 21
`Hw.Er`	Hardware error	p. 21

Error codes from p. 22

Code	What it means	Page
`rnt.F`	Remote input failure. The PDSIO® input is open circuit (PDSIO modes also known as SST Smart Setpoint Transmission)	p. 22
`LLLL`	Out of Display range, low reading	p. 22
`HHHH`	Out of Display range, high reading	p. 22
`Err 1`	Error 1: ROM self-test fail	p. 22
`Err2`	Error 2: RAM self-test fail	p. 22
`Err3`	Error 3: Watchdog fail	p. 22
`Err4`	Error 4: Keyboard failure Stuck button, or a button was pressed during power up.	p. 22
`Err5`	Error 5: Input circuit failure	p. 22
`Pwr.F`	Power failure. The line voltage is too low	p. 22

Alarm codes from p. 90

Code	What it means	Page
`-LCr`	Low Current	p. 90
`-HCr`	High Current	p. 90
`LdF`	Load Fail	p. 90
`HrF`	Heater Fail	p. 90
`S5rF`	SSR Fail	p. 90

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with Eurotherm. Found a mistake? Report an error.