Alarm codeF142
Sensor check. No conductivity display. Possible reasons: Sensor in air, Sensor defective. The manual's first action is: “Remedy: Check sensor installation, Replace sensor”
- Model
- Endress+Hauser CM14
- Display shows
- Sensor signal (F142)
- Type
- Alarm code
- Source
- Manual p. 29
What F142 means
Sensor signal p. 29
Common causes
- Sensor check. No conductivity display. Possible reasons: Sensor in air, Sensor defective. p. 29
What to do
- Remedy: Check sensor installation, Replace sensor p. 29
Before you service the product, read the safety instructions in the manual p. 5.
If F142 is still not resolved
- contact your Endress+Hauser Sales Center for clarification p. 5 “If you are unsure, please contact your Endress+Hauser Sales Center for clarification.”
- contact your sales center for information on modifications or updates to the Operating Instructions p. 5 “Please contact your sales center for information on modifications or updates to the Operating Instructions.”
This page summarises what the manufacturer’s manual says about F142; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Endress+Hauser. Found a mistake? Report an error.