Error codeB308
An error occurs when the system executes the polar coordinate interpolation command. The manual's first action is: “Check if the polar coordinate interpolation complies with the command format.”
- Model
- Delta IA-CNC_Milling
- Display shows
- Polar coordinate interpolation error (B308)
- Type
- Error code
- Source
- Manual p. 428
What B308 means
Polar coordinate interpolation error p. 428
Common causes
- An error occurs when the system executes the polar coordinate interpolation command. p. 428
- Check if the polar coordinate interpolation includes unsupported G code commands. p. 428
- Check whether the polar coordinate interpolation is in the following conditions: 1. The system is in fixed spindle speed mode. 2. The tool nose compensation is canceled. 3. The system is in C axis mode. p. 428
What to do
- Check if the polar coordinate interpolation complies with the command format. p. 428
- Check if there is a specified tool number in the polar coordinate interpolation. p. 428
Before you service the product, read the safety instructions in the manual p. 3.
If B308 is still not resolved
- Contact service / dealer p. 3 “Refer to the pin assignment when wiring.”
This page summarises what the manufacturer’s manual says about B308; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Delta. Found a mistake? Report an error.