Delta IA-CNC_Milling Error 3219: Auto update is set, please reboot

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error code3219

Automatic firmware update is set but requires reboot; the firmware file must be placed in the [pkt] folder on a USB disk. The manual's first action is: “Cycle the power to start the automatic firmware update function. You must put the firmware file in the [pkt] folder in the root directory of the USB disk.”

Model
Delta IA-CNC_Milling
Display shows
Auto update is set, please reboot (3219)
Type
Error code
Source
Manual p. 422

What 3219 means

Auto update is set, please reboot p. 422

Common causes

  • Failed to remotely enable the firmware update function. p. 422

What to do

  1. Cycle the power to start the automatic firmware update function. You must put the firmware file in the [pkt] folder in the root directory of the USB disk. p. 422

Before you service the product, read the safety instructions in the manual p. 3.

If 3219 is still not resolved

  • Contact service / dealer p. 3
    “Refer to the pin assignment when wiring.”
Open the manual at page 422 All IA-CNC_Milling error codes Manual details & download

This page summarises what the manufacturer’s manual says about 3219; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Delta. Found a mistake? Report an error.