CLRWTR GT Series Error ER61: Data run error

Water purifier · taken from the manufacturer’s manual, pages cited

Error codeER61

Data run error occurs when an invalid register or relay number is specified during screen creation using GTWIN, or a NAK error is returned from the PLC. The manual's first action is: “Correct the output device being used with the part, or the transfer of clock data to an external device.”

Model
CLRWTR GT Series
Display shows
Data run error (ER61)
Type
Error code
Source
Manual p. 121

What ER61 means

Data run error p. 121

Common causes

  • A register or relay number which doesn't exist in the PLC was specified during screen creation using GTWIN. p. 121
  • A NAK error has been returned from the PLC. p. 121

What to do

  1. Correct the output device being used with the part, or the transfer of clock data to an external device. p. 121
  2. Verify the PLC settings. p. 121

Before you service the product, read the safety instructions in the manual p. 2.

If ER61 is still not resolved

  • contact service / dealer p. 2
    “Do NOT USE THE PROGRAMMABLE DISPLAY TO CONTROL SAFETY FEATURES OR OTHER CRITICAL OPERATIONS OF EQUIPMENT OR SYSTEMS.”
  • contact service / dealer p. 2
    “A COMMUNICATION ERROR (FOR ANY REASON) MIGHT PREVENT SUCH SAFETY FEATURES OR CRITICAL OPERATIONS FROM FUNCTIONING PROPERLY.”

This page summarises what the manufacturer’s manual says about ER61; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with CLRWTR. Found a mistake? Report an error.