Error codeER00
Time up error happens if the PLC connection cable is disconnected or due to noise interference, possibly with incorrect BCC value. The manual's first action is: “Check the wiring of the connection cable and check for disconnection.”
- Model
- CLRWTR GT Series
- Display shows
- Time up error (ER00)
- Type
- Error code
- Source
- Manual p. 124
What ER00 means
Time up error p. 124
Common causes
- 1) PLC connection cable is disconnected. p. 124
- 2) It is a temporary error caused by noise, etc. p. 124
- The value of BCC may be incorrect. p. 124
What to do
- Check the wiring of the connection cable and check for disconnection. p. 124
- Turn on the power supplies for PLC or GT again. p. 124
- Check if there is no calculation mistake. p. 124
Before you service the product, read the safety instructions in the manual p. 2.
If ER00 is still not resolved
- contact service / dealer p. 2 “Do NOT USE THE PROGRAMMABLE DISPLAY TO CONTROL SAFETY FEATURES OR OTHER CRITICAL OPERATIONS OF EQUIPMENT OR SYSTEMS.”
- contact service / dealer p. 2 “A COMMUNICATION ERROR (FOR ANY REASON) MIGHT PREVENT SUCH SAFETY FEATURES OR CRITICAL OPERATIONS FROM FUNCTIONING PROPERLY.”
This page summarises what the manufacturer’s manual says about ER00; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with CLRWTR. Found a mistake? Report an error.
