Centurion Systems SDO4 Error E1: Safety Beam Active

Garage door operator · taken from the manufacturer’s manual, pages cited

Error codeE1

Safety Beam Active indicates the safety beams are active, requiring alignment or connection checks. The manual lists no action for this code.

Model
Centurion Systems SDO4
Display shows
Safety Beam Active (E1)
Type
Error code
Source
Manual p. 58

What E1 means

Safety Beam Active p. 58

Common causes

  • Align Safety Beams, Check connections, select two-wire or four-wire safety beams with corresponding jumper. p. 58

If E1 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Centurion Systems service.

This page summarises what the manufacturer’s manual says about E1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Centurion Systems. Found a mistake? Report an error.