A&D GX series Error FUL: Memory full

A&D GX series · taken from the manufacturer’s manual, pages cited

Error codeFUL

Memory is full because too much weighing or calibration data has been stored, exceeding the maximum capacity of 50 sets. The manual's first action is: “Delete data in memory to store new data. For details, refer to "11. DATA MEMORY".”

Model
A&D GX series
Display shows
Memory full (FUL)
Type
Error code
Source
Manual p. 75

What FUL means

Memory full p. 75

Common causes

  • The amount of weighing data in memory has reached the maximum capacity. p. 75
  • The amount of calibration or calibration test data in memory has reached the maximum capacity (50 sets). p. 75

What to do

  1. Delete data in memory to store new data. For details, refer to "11. DATA MEMORY". p. 75
  2. The data in memory will be deleted automatically to store new data. For details, refer to "11. DATA MEMORY". p. 75

If FUL is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact A&D service.

Open the manual at page 75 All GX series error codes Manual details & download

This page summarises what the manufacturer’s manual says about FUL; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with A&D. Found a mistake? Report an error.