Industrial

This document describes the features and characteristics of Philips Semiconductors BT131W series logic level triacs, which are suitable for surface mounting and intended for use in general purpose bidirectional switching and phase control applications. These devices can be directly interfaced to microcontrollers, logic integrated circuits, and other low power gate trigger circuits.

LM741 is a general purpose operational amplifier produced by National Semiconductor Corporation, which features improved performance over industry standards such as LM709. It can replace 709C, LM201, MC1439 and 748 in most applications. The amplifier offers many features that make its application nearly foolproof: overload protection on the input and output, no latch-up when the common mode range is exceeded, as well as freedom from oscillations. LM741C/LM741E are identical to the LM741/LM741A except that the LM741C/LM741E have their performance guaranteed over a 0˚C to +70˚C temperature range, instead of −55˚C to +125˚C.

CA741, CA741C, CA1458, CA1558, LM741, LM741C, LM1458 0.9MHz Single and Dual, High Gain Operational Amplifiers for Military, Industrial and Commercial Applications

The LM74 is a temperature sensor, Delta-Sigma analog-to-digital converter with an SPI and MICROWIRE compatible interface. It has 12-bit plus sign temperature resolution and operates over a temperature range of -55°C to +150°C. The LM74's low supply current and simple SPI interface make it ideal for a wide range of applications, including thermal management and protection applications in hard disk drives, printers, electronic test equipment, and office electronics.

This manual is an installation guide for the XMFM1 FM Direct adapter. It describes the components of the adapter and how to connect it to the vehicle's radio and antenna.

This document is the XM SureConnect Vehicle Installation Guide, which provides instructions on how to properly install and use the device. The document emphasizes that the user must use the power cable with the ferrite beads, as not doing so may interfere with radio communications. Additionally, the document mentions that the device complies with Part 15 of the FCC Rules and provides reasonable protection against interference in a residential installation.

lm7372 is a dual operational amplifier that offers high slew rate, low power consumption and wide gain bandwidth product. it is ideal for video and high speed signal processing applications

The LM733 is a differential amplifier produced by National Semiconductor. It has a bandwidth of 120MHz and selectable gains. It is suitable for magnetic tape systems, disk file storage devices, thin film memories, linear amplifiers, etc.

The LM7301 is a low power, 4 MHz gain-bandwidth, rail-to-rail input-output operational amplifier. It offers features such as greater than rail-to-rail input range, full rail-to-rail output swing, large capacitive load driving ability, and low distortion. With a supply current of only 0.6 mA, the LM7301 supports new portable applications without draining battery life. It can be driven by voltages that exceed both power supply rails, eliminating concerns over exceeding the common-mode voltage range. The rail-to-rail output swing capability provides maximum dynamic range at the output, which is important for low supply voltage operation. Operating on supplies of 1.8V–32V, the LM7301 is excellent for a wide range of applications in low power systems. Placing the amplifier right at the signal source reduces board size and simplifies signal routing. The LM7301 fits easily on low profile PCMCIA cards.

LM9074EP Enhanced Plastic System Voltage Regulator with Keep-Alive ON/OFF Control

LM725 is an operational amplifier produced by National Semiconductor Corporation. It has high open loop gain, low input voltage drift, high common mode rejection ratio, low input noise current, low input offset current, high input voltage range, wide power supply range, offset elimination function and output short circuit protection function. It is suitable for low level instrumentation applications.

LM723 is a monolithic integrated programmable voltage regulator, assembled in 14-lead dual in-line plastic and SO-14 micropackage. The circuit provides internal current limiting. When the output current excedes 150mA an external NPN or PNP pass element may be used. Provisions are made for adjustable current limiting and remote shut-down.

The LM723/LM723C is a voltage regulator designed primarily for series regulator applications. It can supply output currents up to 150 mA by itself, and external transistors can be added to provide any desired load current. The circuit features extremely low standby current drain, and provision is made for either linear or foldback current limiting. The LM723/LM723C is also useful in a wide range of other applications such as a shunt regulator, a current regulator or a temperature controller. The LM723C is identical to the LM723 except that the LM723C has its performance guaranteed over a 0˚C to +70˚C temperature range, instead of −55˚C to +125˚C.

This document is a user guide for Agilent Technologies' Agilent G2565CA Scanner with SureScan high-resolution technology. It is intended for research purposes only and not for diagnostic procedures.

This manual describes the configuration of the Agilent G1978A Multi-mode Source.