Texas Instruments manuals, page 36
TEXAS INSTRUMENTS CD74AC139 CD74ACT139 Manual
CD74AC139/CD74ACT139 are dual 2-to-4-line decoders/demultiplexers that utilize the Harris Advanced CMOS Logic technology.
TEXAS INSTRUMENTS CD74AC138 CD74ACT138 CD74AC238 CD74ACT238 Manual
CD74AC138/CD74AC238 are 3-to-8-line decoders/demultiplexers that utilize the Harris Advanced CMOS Logic technology. Both circuits have three binary select inputs (A0, A1, and A2). If the device is enabled, these inputs determine which one of the eight normally HIGH outputs of the AC/ACT138 will go LOW or which on of the normally LOW outputs of the AC/ACT238 will go HIGH.
TEXAS INSTRUMENTS CD54AC112 CD74AC112 Manual
CD54AC112 and CD74AC112 are dual J-K negative-edge-triggered flip-flops with clear and preset. The device contains two independent J-K negative-edge-triggered flip-flops. A low level at the preset (PRE) or clear (CLR) inputs sets or resets the outputs, regardless of the levels of the other inputs. When PRE and CLR are inactive (high), data at the J and K inputs meeting the setup-time requirements is transferred to the outputs on the negative-going edge of the clock pulse (CLK). Clock triggering occurs at a voltage level and is not directly related to the fall time of the clock pulse. Following the hold-time interval, data at the J and K inputs may be changed without affecting the levels at the outputs. These versatile flip-flops can perform as toggle flip-flops by tying J and K high.
TEXAS INSTRUMENTS CD54/74AC109 CD54/74AC112 CD54/74ACT109 CD54/74ACT112 Manual
This document describes the features and characteristics of products such as CD54/74AC109, CD54AC112, CD45ACT109, and CD54ACT112.
TEXAS INSTRUMENTS CD74AC10 CD74ACT10 Manual
This document presents the data sheet of Harris Semiconductor SCHS227, including the typical propagation delay, exceeding 2kV ESD protection, SCR-Latchup-resistant, low power consumption, balanced propagation delays, and other features.
TEXAS INSTRUMENTS CD54/74AC08 CD54/74ACT08 Manual
The SCHS226A is a quad 2-input AND gate from Harris Semiconductor. This product features buffered inputs, a typical propagation delay of 4.3ns, exceeds 2kV ESD protection, SCR-Latchup-Resistant CMOS process and circuit design, speed of Bipolar FAST™/AS/S with significantly reduced power consumption, balanced propagation delays, AC types feature 1.5V to 5.5V operation and balanced noise immunity at 30% of the supply.
TEXAS INSTRUMENTS CD54AC05 CD74AC05 Manual
CD54AC05 and CD74AC05 are six-channel inverters with open drain outputs. They operate from 1.5-5.5V and have balanced noise immunity at 30% of the supply voltage. They also have balanced propagation delays and ±24-mA output drive current, allowing fanout to 15 F devices.
TEXAS INSTRUMENTS CD74AC04 CD74ACT04 CD74AC05 CD74ACT05 Manual
CD74AC04, CD74ACT04, CD74AC05 and CD74ACT05 are hex inverters that utilize the Harris Advanced CMOS Logic technology. They feature fast switching speed, low power consumption, good anti-static ability, large output drive current, and can drive 50 ohm transmission lines.
TEXAS INSTRUMENTS CD54/74AC02 CD54/74ACT02 Manual
SCHS224A is a quad 2-input NOR gate produced by Texas Instruments. It uses advanced CMOS logic technology and has a typical propagation delay of 6ns, 2kV ESD protection, ±24mA output drive current, can drive 15 FAST™ ICs or 50Ω transmission lines, and works over a voltage range of 1.5V to 5.5V.
TEXAS INSTRUMENTS CD74AC00 CD74ACT00 Manual
The CD74AC00 and CD74ACT00 are quad 2-input NAND gates that utilize the Harris Advanced CMOS Logic technology.
Texas Instruments PT6440 Series Integrated Switching Regulator Datasheet
Datasheet 10 pages · 188 KB · ENThe PT6440 series are 6‑A, 5‑V/3.3‑V input adjustable integrated switching regulators with up to 91% efficiency and a small copper‑case footprint.
TEXAS INSTRUMENTS PT6400 Series handbook
The PT6400 is a high performance +5V to +3.3V, 3 Amp, 12-Pin SIP (Single In-line Package) Integrated Switching Regulator (ISR) designed for stand alone (not parallelable) op- eration.
TEXAS INSTRUMENTS SLTS179A handbook(1)
The PT6360 Excalibur™ series of integrated switching regulators (ISRs) combines outstand- ing power density with a comprehensive list of features. They are an ideal choice for applications where board space is a premium and performance cannot be compromised. These modules provide up to 11 A of output current, yet are housed in a low- profile, 12-pin, package that is almost half the size of the previous product generation. The inte- gral copper case construction requires no heatsink, and offers the advantages of solderability and a small footprint (0.64 in² for suffix ‘N’). Both through-hole and surface mount pin configura- tions are available. The PT6360 series operates from a 12-V input bus
TEXAS INSTRUMENTS SLTS179A handbook
PT6360 series 11A 12V input adjustable integrated switching regulator, with 12V input, 11A output current, DSP compatible, >90% efficiency, adjustable output voltage, on/off inhibit function and over-current protection.
TEXAS INSTRUMENTS PT6300 Series 3 Amp Adjustable Positive Step-down Integrated Sw itching Regulators handbook
PT6300 Series is a line of High-Performance 3 Amp, 12-Pin SIP (Single In-line Package) Integrated Switching Regulators (ISRs) designed to meet the on-board power conversion needs of battery powered or other equipment requiring high efficiency and small size. It offers a unique combination of features combining 90% typical effi- ciency with open-collector on/off control and adjustable output voltage.