TEXAS Manuals

This datasheet provides SN54LV14A, SN74LV14A HEX SCHMITT-TRIGGER INVERTERS data information, including product features, package, pin definition, etc.

SN54LS31, SN74LS31 DELAY ELEMENTS are a product produced by Texas Instruments

SN54HC595, SN74HC595 is 8-bit serial-in, parallel-out shift registers with 3-state output registers.

This document describes the features and characteristics of the Klixon series thermostats, including reliable make/break action, various mounting options, factory calibrated temperature setting, high capacity, and extra high capacity. These thermostats are suitable for applications such as air conditioners, heating and ventilating equipment, vending machines, dryers, and unit heaters.

The TPIC5323L is a monolithic gate-protected logic-level power DMOS array that consists of three electrically isolated independent N-channel enhancement-mode DMOS transistors.

This document describes the features and characteristics of the CD74AC257, CD74ACT257, and CD74ACT258 products from Harris Semiconductor, including non-inverting outputs, buffered inputs, typical propagation delay, exceeding 2kV ESD protection, SCR-Latchup-Resistant CMOS process and circuit design, fast speed with significantly reduced power consumption, balanced propagation delays, AC types with 1.5V to 5.5V operation and 30% supply noise immunity, ±24mA output drive current, etc.

The document provides the data sheet of Harris Semiconductor SCHS154D. The CD54HCT161 is obsolete and no longer supplied. The product features a 4-bit binary counter, asynchronous reset, synchronous counting and loading, two count enable inputs for cascading, and look-ahead carry for high-speed counting.

This document is a PDF datasheet of CD4011B, CD4012B, and CD4023B types, including their packaging types, pin counts, package quantities, eco plan, lead/ball finish, MSL peak temperature, etc.

The 'ACT16861 are noninverting 20-bit transceivers designed for asynchronous communication between data buses. The control-function implementation minimizes external timing requirements. The 'ACT16861 can be used as two 10-bit transceivers or one 20-bit transceiver. They allow data transmission from the A bus to the B bus or from the B bus to the A bus, depending upon the logic level at the output-enable (OEAB or OEBA) inputs. The output-enable inputs can be used to disable the device so that the buses are effectively isolated. The 74ACT16861 is packaged in TI's shrink small-outline package, which provides twice the I/O pin count and functionality of standard small-outline packages in the same printed-circuit-board area. The 54ACT16861 is cha

This datasheet introduces the features and characteristics of SN54LVTH244A and SN74LVTH244A, including working voltage, input and output voltage, input current, output current, package, etc.

SN54ALS688, SN74ALS688 8-BIT IDENTITY COMPARATORS SDAS228A datasheet, the datasheet introduces the features and characteristics of the product, including function table, pin diagram, package, etc.

The 54ACT16827 and 74ACT16827 are members of the Texas Instruments Widebus family. They are 20-bit buffers/drivers with 3-state outputs. Inputs are TTL-voltage compatible. 3-state outputs drive bus lines directly. Flow-through architecture optimizes PCB layout. Distributed VCC and GND pin configuration minimizes high-speed switching noise. EPIC (Enhanced-Performance Implanted CMOS) 1-µm process. Typical latch-up immunity at 125°C is 500 mA. Package options include plastic 300-mil shrink small-outline (DL) packages using 25-mil center-to-center pin spacings and 380-mil fine-pitch ceramic flat (WD) packages using 25-mil center-to-center pin spacings.