Key facts
- Manuals
- 1
- Languages
- EN
- Last added
- 2026-11-17
Featured Equilibar manuals

Equilibar EPC High Resolution Electronic Pressure Controller Installation & Operating Instructions
The Equilibar EPC is a closed-loop pressure control valve system that maintains a steady and repeatable downstream pressure as demand or process changes occur. It is supplied in an IP65 rated enclosure for manufacturing and industrial environments, and each unit contains two internal solenoid valves, a manifold, an electronic control circuit board and a pressure transducer. This 16-page document gives the installation and operating instructions, including safety precautions, specifications, dimensions, mounting, pneumatic plumbing and calibration.
The text explains how the EPC works: the inlet solenoid valve opens proportionally to the control circuit current to raise pressure, while the exhaust valve vents to atmosphere to lower it, and the internal transducer feeds a pressure signal back to the control circuit. It also covers analog electrical connections and pin-out for the 0-10 VDC command signal, serial PuTTY configuration and serial commands, flow and orifice selection, part number information, accessories and warranty information. EPC units are calibrated at the factory to NIST standards, and any change of calibration must be done by returning the unit to Equilibar.
Covers: Safety Information · Specifications · Operational Description · Dimensions · Mounting · Pneumatic Plumbing
Latest Equilibar manuals
Equilibar EPC High Resolution Electronic Pressure Controller Installation & Operating Instructions
User Manual 16 pages · 2 MB · ENInstallation and operating instructions for the Equilibar EPC closed-loop electronic pressure controller, with specifications, plumbing, wiring and calibration.
Which document do I need?
User Manual
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in Equilibar manuals
What power supply and command signal does the EPC need?
The EPC requires 15 to 24 VDC on Pin 8 of the electrical connector and uses a 0 to 10 VDC command signal on Pin 1. The power supply ground, command source ground and Pin 3 must be tied together.
Can the EPC be mounted in any orientation?
Yes. The EPC is not sensitive to position and may be mounted in any orientation, and it comes standard with top-down mounting holes for flat surfaces.
