Key facts
- Brand
- Okuma
- Model
- OSP-U100M
- Category
- Industrial Robot
- Documents
- 2
- Languages
- EN
- Last added
- 2023-10-19
Start here

Okuma OSP-U100M OSP-U10M Alarm & Error List
This document provides detailed information on alarms and errors for Okuma’s OSP-U100M and OSP-U10M machine control systems. It includes safety precautions for installation, operation, maintenance, and troubleshooting. The alarms are classified into six types: CPU, P, A, B, C, and D, each with specific behaviors and handling procedures. Operators are instructed to follow safety guidelines to prevent accidents and ensure proper machine operation.
The manual also covers emergency procedures, power shutdown protocols, and precautions during maintenance. It emphasizes the importance of using only specified parts, turning off power before inspection, and handling sensitive components like NC unit memory boards with care to avoid data loss.
Okuma OSP-U100M specifications
| Ambient temperature (machine) | 17 to 25 C |
|---|---|
| Ambient humidity (machine) | 40% to 75% |
| Permissible ambient temperature (control enclosure) | 0 to 40° C |
| Maximum altitude (control enclosure) | 1000 m |
| Voltage fluctuation | ±10% max. |
| Power supply frequency | 50/60 Hz |
All Okuma OSP-U100M documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
How should the power be turned off?
Turn off the CONTROL ON switch on the operation panel first, then the main power disconnect switch.
Who is permitted to perform work on servo amplifiers and spindle drive units?
Only service personnel are permitted to perform work on these units.
What are the safety precautions for installing the machine?
Install the machine in an environment with ambient temperature 17 to 25 °C, humidity 75% or less, no direct sunlight or excessive vibration, and free from dust, acid, corrosive gases, and salt spray.
How should I turn off the power when finishing work?
Turn off the CONTROL ON switch on the operation panel first, then the main power disconnect switch.
