Key facts
- Brand
- NetApp
- Model
- ONTAP 9
- Category
- Storage devices
- Documents
- 4
- Languages
- EN
- Last added
- 2023-10-27
Start here

NetApp ONTAP 9 Upgrade and Revert/Downgrade Guide
This guide describes how to manually upgrade, downgrade, or revert an ONTAP cluster or a MetroCluster configuration using nondisruptive or disruptive processes. It also details how to perform an automated upgrade using the command line interface (CLI). Note that this is archived content applicable to downgrading from ONTAP 9.1 to 9.0 and includes information specific to single-node clusters, which are no longer offered by NetApp. For the most current documentation, users should refer to the NetApp support site.
Read onlineNetApp ONTAP 9 specifications
| Encryption Algorithm | XTS-AES-256 |
|---|---|
| Supported Platforms | ONTAP 9.9.1 and later |
| Encryption Scope | Volume level or Aggregate level |
All NetApp ONTAP 9 documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What are the two main encryption technologies offered?
NetApp offers software-based encryption (NVE) for volume-by-volume encryption and hardware-based encryption for full-disk encryption (FDE).
When is external key management recommended?
External key management is recommended if FIPS 140-2 or OASIS KMIP compliance is required, or for centralized multi-cluster key management.
When should you call technical support for an upgrade?
You should call technical support if you encounter problems during or after the upgrade, or if you want to downgrade or revert a production cluster.
Is the automated upgrade procedure preferred for MetroCluster configurations?
Beginning in ONTAP 9.3, the automated upgrade procedure is the preferred upgrade method for all configurations, including MetroCluster configurations.
When should I use this guide versus the CLI?
You should use this guide if you want to use ONTAP System Manager to perform an automated upgrade. However, using ONTAP System Manager is preferred over the command line interface.
Can I perform an automated upgrade on a single-node cluster?
Yes, beginning with ONTAP 9.4, you can perform an automated upgrade on a single-node cluster. For clusters running ONTAP 9.3 or earlier, you should use the CLI procedures.
