Key facts
- Brand
- Furman
- Model
- PS-8RE III
- Industry
- Electronics
- Documents
- 2
- Languages
- ZH · EN
- Last added
- 2026-11-15
Start here

Furman PS-8RE III Power Conditioner / Sequencer Owner's Manual
The Furman PS-8RE III is a power conditioner and sequencer designed for large A/V systems. It features Furman's exclusive SMP+ (Series Multi-Stage Protection Plus) technology, which provides unparalleled clamping voltage protection against extreme line voltage conditions. The unit also utilizes LiFT (Linear Filtering Technology), a finely tuned low-pass filter designed to reduce differential AC noise without the resonant peaking found in traditional filters.
The device includes three delay stages for power sequencing, allowing users to power up signal processing equipment before amplifiers to prevent speaker pops and circuit breaker trips. It offers remote operation via a legacy-style interface and includes multi-color LED indicators for status monitoring. The manual provides instructions on safety, features, operation, and troubleshooting.
FURMAN PS-8RE III specifications
| Maximum AC Current Rating | 10 Amps, 220 - 240 VAC @ 50 – 60 Hz |
|---|---|
| AC Cord | 1 mm² x 3, 2.5 m length, IEC-C13 (Female) to CEE-7/7 Schuko plug |
| AC Inlet | IEC-C14 (Male) with metal wire retainer clip |
| AC Outlets | Front Panel: 1 Switched IEC C-13; Rear Panel: 2 Switched IEC C-13 (1 duplex), 6 Sequenced IEC C-13 (3 duplexes) |
| AC Surge Protection | Spike Clamping Voltage: 376VAC peak @ 6,000 Volts/3,000 Amps |
| AC Over-voltage Protection | EVS, 275VAC+/-5VAC |
| Noise Attenuation | 10dB @10KHz, 40dB@100KHz, 50dB@500KHz |
| Dimensions | 7”D x 19”W x 1.75”H |
| Weight | 7 lbs |
Source: FURMAN PS-8RE III 10A Power Conditioner and Sequencer
All FURMAN PS-8RE III documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What is the maximum current rating of the PS-8RE III?
10 Amps, 220 - 240 VAC @ 50 – 60 Hz (Thermal breaker).
How is the delay interval between outlets configured?
The delay interval is factory preset to approximately 5 seconds and can be adjusted by changing the position of the DLY-ADJ trim pot on the rear panel.
What is the clamping voltage of the Furman PS-8RE III?
The SMP+ technology clamps at 376 Vpeak, which is 266 VAC RMS.
From: Furman PS-8RE III Power Conditioner / Sequencer Owner's Manual
How many delay stages does the PS-8RE III have?
The unit provides three delay stages for power sequencing.
From: Furman PS-8RE III Power Conditioner / Sequencer Owner's Manual
