Key facts
- Brand
- D'Amore Engineering
- Model
- DD-1
- Category
- Other Electronics
- Industry
- Electronics
- Documents
- 2
- Languages
- EN
- Last added
- 2026-11-16
Start here

D'Amore Engineering DD-1 Distortion Detector Owner's Manual
The D'Amore Engineering DD-1 Distortion Detector is an analog tool for setting an audio amplifier's gain to match a source unit's output level and for detecting distortion in audio signals. The manual covers measuring a headunit alone or through an amplifier, setting gain for full-range and subwoofer amplifiers, power requirements, and specifications.
It also includes troubleshooting, guidance on crossover and infrasonic filter settings, the DD-1 CD track list, and limited warranty information.
D'Amore Engineering DD-1 specifications
| Circuitry | 100% analog |
|---|---|
| Distortion detection trigger level | >1.0% harmonic distortion |
| Guaranteed operating range (input signal) | 1.2Vrms to 125Vrms (15,000 W at 1 ohm), autoranging |
| Signal Present LED trigger voltage | 750mVrms |
| Low Battery LED trigger voltage | <5.6Vdc |
| Auto-shutoff timer | 8 to 10 minutes after ON button is pressed |
| Power source | 9V battery |
Source: D'Amore Engineering DD-1 Distortion Detector Owner's Manual
All D'Amore Engineering DD-1 documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What power source does the DD-1 use?
It uses a 9V battery, and the manual says not to run it from any other power source.
From: D'Amore Engineering DD-1 Distortion Detector Owner's Manual
At what distortion level does the DD-1 trigger?
The distortion detection trigger level is greater than 1.0% harmonic distortion.
From: D'Amore Engineering DD-1 Distortion Detector Owner's Manual
What power source does the DD-1 use?
The DD‑1 is powered by a 9 V battery and must not be connected to any other power source.
From: D'Amore Engineering DD-1 Distortion Detector Owner's Manual
How do I set the gain of a full‑range amplifier with the DD‑1?
Connect the DD‑1 to the amplifier output, set the amplifier gain to minimum, then slowly turn up the gain until the Distortion LED stays lit, and back down until it just turns off.
From: D'Amore Engineering DD-1 Distortion Detector Owner's Manual
