Yongbo Servo Drive Tuning Steps Simplified Manual

This manual provides simplified instructions for wiring and debugging Yongbo servo drives, covering power connections, signal wiring, encoder setup, and…

Yongbo Servo Drive Tuning Steps Simplified Manual - cover page
Brand
Yongbo
Document type
User Manual
Language
Chinese
Pages
4
File format
PDF
File size
243 KB
Published
17 October, 2026
Updated
17 October, 2026
MD5 checksum
B46EF1A0D2D97638EA843A028F0F5C2A
PDF
Yongbo Servo Drive Tuning Steps Simplified Manual PDF

About this manual

This document serves as a simplified guide for the commissioning of Yongbo servo drives. It outlines general procedures for verifying equipment models, checking installation environments, and performing initial checks on power and motor output wiring.

The manual details specific wiring configurations for peripheral devices, signal connections based on control modes (position, velocity, torque), and encoder interface setups for different motor power ratings. It also explains how to configure key parameters such as rotation direction, control mode selection, pulse input formats, analog gain settings, and electronic gear ratios. This manual is written in Chinese.

What's inside

  • Check Servo Drive and Motor
  • Peripheral Device Wiring Diagram
  • Signal and Wiring Configuration
  • Encoder Wiring Specifications
  • CN2 Connector Definition
  • Parameter Adjustment: Pn-000
  • Parameter Adjustment: Pn-200
  • Parameter Adjustment: Pn-300 to Pn-400

Specifications

Encoder Wire Gauge0.13mm (26AWG)
Wire Type StandardUL2464
DI/DO Power Requirement12V — 24V

Frequently asked questions

What is the default value for parameter Pn-000?

The default value is 0010.

How should external regenerative resistors be connected?

They should be connected to terminals B1 and B2, with B2 and B3 left open.

Download PDF (243 KB)