The user manual for Yinhe Electric's VSV701-G150T01-I voltage sensor provides installation, operation, safety, and technical specifications.
The VSV701-G150T01-I voltage sensor is designed for isolated measurement of DC, AC, pulse and irregular waveforms, targeting high‑accuracy metrology, power quality analysis, medical, aerospace, and industrial applications. It offers high accuracy, linearity, stability, sensitivity, low noise, wide bandwidth and analog output.
The manual covers safety procedures, electrical performance, accuracy parameters, mechanical dimensions, terminal definitions, power‑supply requirements, wiring diagrams, packaging contents and handling notes. Users are advised to read the guide before installation, disconnect power when moving the device, and contact technical support for any safety concerns. This manual is written in Chinese.
| Primary rated voltage | 700 Vrms |
|---|---|
| Voltage test range | 1000 Vp |
| Operating voltage | ±15 Vdc |
| Current consumption | ±80 mA |
| Accuracy (Xe) | 0.05 % |
| Linearity (εL) | 100 ppm |
| Phase error (Δφ) | 0.0315° |
| Bandwidth (‑3 dB) | 0‑200 kHz |
| Operating temperature range | -10 °C to +70 °C |
A high‑quality ±15 V linear power supply is required.
The output uses a 4‑pin terminal with pins + (positive Vcc), - (negative Vcc), G (ground), and M (measurement signal).
Connect the high‑end of the measured voltage to the ‘+’ terminal and the low‑end to the ‘‑’ terminal of the 2‑pin input connector.