Yi Zhi Yu Xin EG06-DT-R01 Smart Elevator IoT Monitoring Device User Manual

Yi Zhi Yu Xin EG06-DT-R01 Smart Elevator IoT Monitoring Device user manual covering product features, installation, and monitoring specifications.


Yi Zhi Yu Xin EG06-DT-R01 Smart Elevator IoT Monitoring Device User Manual - cover page
Brand
易之于心
Category
Monitoring Equipment
Document type
User Manual
Language
Chinese
Pages
13
File format
PDF
File size
841 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
23D1D873C5EAF726A0108E4D5D7D7F6A

About this manual

The Yi Zhi Yu Xin EG06-DT-R01 is a smart elevator IoT monitoring device, also described as an elevator black box. It uses integrated installation, is compact at within 90*45*13mm, and contains built-in sensors so no extra physical collection points are needed. It monitors elevator operation in real time, supports 4G networking, and serves elevator safety warnings, on-demand maintenance, and digital supervision.

The document covers product introduction, operation, and installation. The device is mounted vertically on the elevator car door header near the center line with its optical sensor exposed. Floor information can be initialized through backend push or manual Wi-Fi configuration using a device assistant, followed by calibration by running the elevator between the bottom and top floors. This manual is written in Chinese.

What's inside

  • Product Introduction
  • Operation Manual
  • Specification Parameters
  • Network Topology Diagram
  • Installation Preparation
  • Device Installation Steps
  • Floor Information Initialization
  • Installation Record Collection
  • Communication Parameters
  • Regulatory Data Platform

Specifications

ModelEG06-DT-R01
Storage64Mbit or more
Transmit power23dBm±2dB
SIM cardNano-SIM card
Communication standardMQTT
Wireless standardIEEE802.11b/g/n
Power supplyDC12V/2A
Operating temperature-20 to 75℃
Dimensionswithin 90*45*13mm

Frequently asked questions

Does the device need to connect to the elevator control system?

No. It collects data through its own built-in sensors and does not need to connect to the elevator's control system or motherboard.

Where should the device be installed?

Install it vertically on the elevator car door header near the center line, keeping the optical sensor exposed and unobstructed.

What is the Wi-Fi name and password for device configuration?

Connect to the black box Wi-Fi whose name starts with TIM; the password is 12345678.

Download PDF (841 KB)