AutoDoc guide for replacing the rear shock absorbers on the Volvo V50 MW, with the tool list and the step-by-step removal procedure.
This French-language AutoDoc guide covers replacing the rear shock absorbers on the Volvo V50 MW and states that the procedure can also be applied to the VOLVO C30 (533) 1.6 D, VOLVO S40 II (544) 1.6 D and VOLVO V50 (545) 1.6 D. It opens with a list of the tools and materials needed, including a No. 19 impact socket for the wheels, No. 15 and No. 10 impact sockets, a No. 13 combination wrench, a DD No. 4 shock absorber bit, a ratchet, a torque wrench, a vise, a wire brush, WD-40, brake cleaner, copper grease and a telescopic hydraulic jack.
The steps start with chocking the wheels, loosening and removing the road wheel, cleaning the shock absorber fastenings with a wire brush and WD-40, supporting the arm with a jack and undoing the lower and then the upper shock absorber attachment, before clamping the shock absorber in a vise and removing the piston rod attachment. AutoDoc advises replacing both rear suspension shock absorbers at the same time and carrying out all operations with the engine switched off. The document closes with a disclaimer and a copyright notice from Autodoc GmbH. This manual is written in French.
| Applicable vehicle models | VOLVO C30 (533) 1.6 D, VOLVO S40 II (544) 1.6 D, VOLVO V50 (545) 1.6 D |
|---|---|
| Engine variant covered | 1.6 D |
The procedure can be applied to the VOLVO C30 (533) 1.6 D, VOLVO S40 II (544) 1.6 D and VOLVO V50 (545) 1.6 D.
Yes, the guide states that both rear suspension shock absorbers must be replaced at the same time.
A No. 15 socket is used together with a tap holder.
The wheels must first be secured with wheel chocks.