User manual for True Manager, the program for basic configuration, diagnostics and firmware upgrade of the TCS-200 video server or IP camera.
True Manager is a program used for basic configuration, diagnostics and F/W upgrade of the TCS-200 video server or IP camera. It can find servers on the LAN and assign IP addresses, monitor server status such as encoding/decoding, serial, sensor and relay ports, run diagnostic tests (PING, network bandwidth measurement, video/audio output port check, serial port check), and perform firmware upgrades.
The manual explains how to register, modify and remove servers, group servers for easier management, connect to and disconnect from servers, monitor general server information and channel status on the Servers, Channels and Peripherals tabs, use the network and system diagnostic tools, upgrade firmware, and open the web-based remote Setup and video Viewer in Internet Explorer.
| Ping test targets | Up to 4 systems |
|---|---|
| Serial ports monitored | RS-232C (COM1) and RS-422/485 (COM2) |
| Sensor and relay ports | 2 sensor ports, 2 relay ports, buzzer |
| Remote setup and viewing | Web-based, via Internet Explorer |
Use the IP Discovery function, which shows all TCS-200 systems on the same LAN as the PC running True Manager and lets you change a server's IP address.
Yes, more than one server can be selected and upgraded simultaneously from the F/W upgrade dialog.
Do not power off the server while the upgrade is in progress, as the server may go to an irrecoverable state. If the network condition is poor and the upgrade fails, retry after the network recovers.
Use the Serial Loopback Test: form a loopback in the port (e.g. connect pin 2 and 3 on RS-232C), and the port is normal if the number of sent bytes equals the number of received bytes.