Installation guide for the TimeTec BLE-2 barrier gate and turnstile controller, covering recommendations, accessories, wiring and inspection.
The TimeTec BLE-2 is a controller for barrier gates and turnstiles. The guide gives installation recommendations for both applications: for barrier gates, install the BLE-2 inside a PVC/plastic enclosure on a gooseneck pole and protect wiring with concealed piping; for turnstiles, install it inside the turnstile housing with the turnstile controller.
The guide lists required accessories, including a working barrier gate/turnstile, the TimeTec BLE-2, a gooseneck pole and a PVC/plastic enclosure. It shows the wiring to the barrier gate/turnstile controller with a 12VDC 3A power supply, then describes primary checks of the BLE-2 LEDs and secondary checks of gate/turnstile operation using the physical buttons and the i-TimeTec mobile app.
| Maximum barrier gates controlled | Two barrier gates simultaneously, only when operating in the same direction |
|---|---|
| Maximum turnstiles controlled | One turnstile at a time |
| Power supply shown in wiring diagram | 12VDC 3A |
A single TimeTec BLE-2 can control a maximum of two barrier gates simultaneously, but only when the gates operate in the same direction. If the gates face different directions, two TimeTec BLE-2 units are required.
A single TimeTec BLE-2 can control one turnstile at a time, even if the turnstile operates in two different directions.
The wiring diagram shows a 12VDC 3A power supply.
It checks the TimeTec BLE-2 LED status, including whether the Bluetooth LED and Power LED are activated and whether the Status LED is blinking.