The guide provides step‑by‑step hardware installation instructions, safety advice, and maintenance procedures for the Tian Gong R2631 modular router.
This document introduces the Tian Gong R2631 modular router, describing its standard configuration, system specifications, and available network/voice modules. It outlines the router’s ports, power options, and physical dimensions to give users a clear picture of the device.
The guide then walks the installer through preparation, safety precautions, mounting the router on a desk or rack, connecting cables, and performing hardware maintenance such as opening the chassis, upgrading SDRAM, and expanding flash memory. Detailed fault‑isolation tips and LED indicator explanations are also included. This manual is written in Chinese.
| CPU | 300 MHz |
|---|---|
| EPROM | 512 KB |
| Flash Memory | 8–40 MB |
| SDRAM | 64 MB |
| Dimensions | 440 mm × 425 mm × 70 mm |
| Operating Temperature / Humidity | 0 °C–40 °C, 10%–85% RH (no condensation) |
| AC Input Voltage | 100 V–240 V |
| DC Input Voltage | -72 V to -36 V |
| Maximum Power Consumption (AC) | 120 W |
| Maximum Power Consumption (DC) | 80 W |
| Console Port Speed | 300 bps–115200 bps, RJ45, no LED |
| AUX Port Speed | 1200 bps–57600 bps, RJ45, no LED |
| Ethernet Ports | 2 × 10/100 Mbps RJ45 |
Only trained personnel should install or replace the router, the power must be disconnected, static‑discharge protection should be used, and the work area must be clean and free of hazards.
Power off the router, remove the chassis cover, locate the SDRAM DIMM slot, release the spring clips, pull out the old module, align the new module’s notches with the slot, insert it vertically, and re‑close the clips before re‑assembling the chassis.
The router can be powered from AC 100‑240 V (max 120 W) or DC –72 V to –36 V (max 80 W).
The R2631 provides three network/voice module slots for optional interface cards.