This manual covers operation, controls, sleep timer, alarm setting, FM tuning, and specifications for the TECSUN PL-118 DSP receiver.
The TECSUN PL-118 is an FM stereo DSP receiver that uses DSP technique to digitalize analog AM/FM broadcasting signals, improving sensitivity, selectivity, S/N ratio and anti-interference.
This operation manual describes control locations, clock and alarm setting, listening to the radio, ETM auto-scan, volume adjustment, FM frequency range, specifications, and important battery usage matters.
| Frequency Range | 87.0 - 108.0 MHz / 76~108 MHz |
|---|---|
| Sensitivity | < 3 V (S/N=30dB) |
| Signal Selection | 60dB (±200kHz) |
| S/N Ratio | > 55dB |
| FM Stereo Crosstalk | > 25dB |
| Output Power | ≥ 100 mW (distortion 10%) |
| Speaker | 40 mm / 16 Ω / 500 mW |
| Earphone | 3.5 mm / 32 Ω |
| Power Source | 2x R03 (AAA) |
| Dimensions | Approx. 100 x 60 x 17 mm |
| Weight | 70 g (excl. battery) |
Press and hold the sleep button until it flashes, then rotate the tuning knob to select 1–120 minutes or permanent sleep.
Install two new R03 (AAA) batteries according to the polarity diagram on the back of the radio.
Turn on the radio, extend the antenna, and press and hold ETM until the frequency runs to auto scan and store stations.
The frequency range is 87.0–108.0 MHz or 76–108 MHz.