Installation guide for the Tair 5 F3K glider, covering hand grip, aileron, tail, and fuselage installation, plus setup and flight modes.
This guide presents the installation of the Tair 5 F3K glider in five steps: hand grip, aileron, tail, and fuselage installation, followed by setup and tuning. It lists consumables and tools for the work, including masking tape, E51 medium-viscosity epoxy, a scale, steel ruler, hobby knife, files, a rotary tool, drill bits, PE film, and a cutting mat.
The aileron section explains the top-drive (TD) servo arrangement and lists servo options from KST, FRSKY, and FUTABA. The setup section describes five flight modes (Preset, Zoom, Cruise, Speed, and Thermal), tail compensation notes, and center-of-gravity positions for different air conditions. This manual is written in Chinese.
| Wing Area | 19.7 dm² |
|---|---|
| Stabilizer Area | 2.2 dm² |
| Rudder Area | 2.2 dm² |
| Rudder Travel | ±15 mm |
| Stabilizer Travel | ±8 mm |
| Normal Center of Gravity | 77 mm |
| Center of Gravity in Strong Wind or Turbulence | Less than 75 mm |
| Center of Gravity in No Wind or Weak Lift | Greater than 78 mm |
The guide lists a normal center of gravity of 77 mm.
It recommends a center of gravity below 75 mm in strong wind and turbulence.
With the servo at neutral and the horn at 90 degrees to the wing, the aileron is set 3 mm down before the servo is fixed.
Cruise is described as the aircraft's most efficient flight state.