User manual for the Supro Delta King 12 tube amplifier, covering safety, front and rear panel controls, tubes, troubleshooting, and warranty.
The Supro Delta King 12 is a 100% analog tube amplifier. This manual covers important safety information, front panel controls including Volume, Boost, Drive, tone controls, Reverb, Master, Standby, and Power, plus rear panel connections for footswitch, Line Out, and Power Amp Input.
The document also identifies the tube complement, provides troubleshooting steps for sound and power issues, and states the Supro limited warranty terms for amplifiers, tubes, and speakers.
| Preamp tube | 12AX7/ECC83 |
|---|---|
| Power tube | 6L6 |
| Power amp section | Class-A |
| Warm-up time before sound | Approximately 1 minute |
| Minimum rear clearance | Four inches (101.6 mm) |
| Fuse (100V-120V) | 3A, 250V |
| Fuse (220V-240V) | 2A, 250V |
| Amplifier warranty | 1 year, extended to 2 years if registered |
| Tubes and speakers warranty | 90 days |
The tubes should warm up for at least one minute before turning the Standby switch to ON. The Power switch should be turned on and the pilot light lit for one minute before switching Standby on.
Check that the speaker is plugged into the speaker jack rather than the footswitch jack, that all knobs are turned up past zero, and that the Standby switch is set to operate. Tube amplifiers take about one minute to warm up.
It provides a direct injection point for the 6L6 power amplifier in the Delta King 12. Plugging into it interrupts the connection between the preamp and power amp so other preamps or modeling hardware can be used.
The warranty covers one year from the original purchase date and extends to two years if the product is registered within 60 days. Register at http://suprousa.com/warranty and submit the warranty request form at http://suprousa.com/support.