Stonepark Screw-On Stone Veneer Technical Data Sheet & Installation Guide

Stonepark Screw-On technical data sheet and installation guide covering stone sizes, weight, screws, corners, finishing, sealing and maintenance.


Stonepark Screw-On Stone Veneer Technical Data Sheet & Installation Guide - cover page
Brand
Stonepark
Category
Other products
Document type
Installation Guide
Language
English
Pages
17
File format
PDF
File size
5.7 MB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
5D831A50E9965A71587A928A2F54DADE

About this manual

This document is the technical data sheet and installation guide for Stonepark Screw-On stone veneer, a manufactured stone product made by Stonepark, a Canadian company. It states basic use and limitations, weight and thickness ranges, stone size tolerance, coloring with iron oxide, surface dust, and the CSA/ASTM standards the product is manufactured to.

The installation part lists the materials and tools needed, how to calculate the area of flats and corners, screw and starter strip requirements, site preparation, general installation procedures for corners, columns, sills and the last row, and the finishing steps. It closes with maintenance, cleaning, efflorescence, sealers and touch-up guidance, plus boxing and packaging figures for the Barnwood and Quickfit Ledge styles.

What's inside

  • Building Code
  • Weight & Thickness
  • Stone Sizes
  • Basic Use & Limitations
  • Colors
  • Surface Dust
  • CSA/ASTM Codes
  • Application Materials & Tools
  • Determine the Area
  • Terminology

Specifications

Average weight per sqft8 lbs – 13 lbs
Thickness1" – 2"
Length and width tolerance±0" to ±3/16"
Screw size#10
Minimum screw insertion into plywood1 ¼"
Corner stone height6 inches
Minimum plywood thickness1/2"
Ground clearance (outdoor)6"
Maximum height without design professional approval30 feet
Barnwood packaging108 sqft per skid, 72 pc per skid, 15 lbs per pc
Quickfit Ledge packaging84 sqft per skid, 84 pc per skid, 12 lbs per pc

Frequently asked questions

What size screws are used for Stonepark Screw-On?

The screws must be size #10, with a minimum insertion of 1 ¼" into the plywood. The length may vary according to the plywood.

Where can Stonepark Screw-On not be used?

It should not be used below water level because chemicals may discolor the product, and paving applications are prohibited.

How should Stonepark Screw-On be cleaned?

Use a soft bristle brush with warm water, then rinse immediately with fresh water. Do not use acid-based or wire brushes, and do not pressure wash the product.

Does the stone color change after manufacturing?

Colors may appear brighter and stronger on newly manufactured stones, and depending on weather and environment the curing process may take up to 12 months for colors to set to the original color.

Download PDF (5.7 MB)