Starke Sound AMP-F2 Stereo Amplifier User Manual

User manual for the Starke Sound AMP-F2 Class D stereo amplifier, covering setup, rear panel connections, bridge mode, trigger control and specifications.


Starke Sound AMP-F2 Stereo Amplifier User Manual - cover page
Brand
Starke sound
Category
audio amplifier
Document type
User Manual
Language
Chinese
Pages
16
File format
PDF
File size
6.8 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
248B8CC527BDEF1D137156AB3E17EC8F

About this manual

This manual describes the Starke Sound AMP-F2, a stereo power amplifier built on the Starke Sound NS600 amp module with a 600 kHz sampling rate and a newly designed SAPS switch mode power supply rated at 600 watts. It uses a high-efficiency Class D design and can be operated as a 2-channel amplifier or bridged as a mono amplifier.

The document covers the rear and front panel controls, setup instructions for standard and bridge mode, speaker and input connections (RCA or XLR), 12V trigger input/output operation, safety instructions, the 1-year limited warranty, and a full specifications table. The manual is presented in both English and Chinese. This manual is written in Chinese.

What's inside

  • Introduction
  • Specifications (性能参数)
  • Hardware / Rear Panel Descriptions
  • Front Panel
  • Set-up instructions
  • Trigger IN/OUT
  • Downloads
  • Safety instructions
  • Limited warranty

Specifications

Output power (stereo)145W RMS at 8 ohms (1% THD); 250W RMS at 4 ohms (1% THD)
Output power (bridged/BTL)280W RMS at 4 ohms; 450W RMS at 2 ohms (1% THD, BTL)
Amplifier typeClass D, 2 channels
Gain21.5dB
Frequency response10Hz-20KHz -1dB
Signal-to-noise ratio>110dB, "A" weighted at 4 ohm
THD0.003% (10W at 1KHz)
Inputs2-channel RCA and 2-channel XLR; 11KΩ (RCA), 22KΩ (XLR); sensitivity 2.7V
Outputs2 pairs beryllium copper binding posts; output impedance 0.136Ω; minimum load impedance 0.8Ω
Power consumptionStandby ≤0.5W, Idle ≤14W, Maximum 900W
Trigger12V trigger input & output, up to 12V DC/150mA
Cabinet / colorAluminum, Black
Warranty1 year from original purchase date

Frequently asked questions

What fuse should I use for the AMP-F2?

Use a 3.15A fuse at 220V-240V, or a 6.3A fuse at 110V-120V. Check the voltage setting before connecting power, as an incorrect fuse can burn the amplifier.

How do I set up bridge mode on the AMP-F2?

Set the BRIDGE switch to BRIDGE (in bridge mode only the inputs and outputs in the diagonal-line area work); for normal stereo operation set it to STD. Connect inputs via RCA or XLR and set the toggle switches to UNBAL or BAL accordingly.

How does the trigger input/output work?

When TRIGGER IN is connected to a device with TRIGGER OUT, the AMP-F2's power on/standby is controlled by the upstream device; TRIGGER OUT can likewise control a downstream device. Trigger signals are up to 12V DC/150mA, and in trigger mode the front panel power button is disabled.

How long is the warranty on the AMP-F2?

The limited warranty is 1 year from the purchase date; keep the original invoice to arrange service through your dealer, or contact Starke Sound directly if purchased online.

Download PDF (6.8 MB)