The SmartQ 7 MID user manual provides safety guidelines, setup steps, operation instructions, and technical specifications for the tablet.
The SmartQ 7 MID is a high‑precision tablet that offers internet connectivity, multimedia playback, office functions, and a variety of built‑in applications. The manual begins with safety precautions, lists the supplied accessories, and describes the device’s key features and hardware layout.
Detailed sections cover basic operations such as powering on, firmware upgrades, touch‑screen calibration, charging, and using the soft keyboard. Additional chapters provide tips, troubleshooting advice, and a full set of technical specifications for the hardware components. This manual is written in Chinese.
| Processor | ARM11 architecture, 667 MHz |
|---|---|
| Memory | DDR RAM 128 MB |
| Storage | 1 GB flash (256 MB user‑available) |
| SD Card Support | SD/SDHC up to 16 GB |
| Wireless | IEEE 802.11 b/g |
| USB Interfaces | USB 2.0 OTG and USB 2.0 Host |
| Audio Output Power | 40 mW |
| Frequency Response | 20 Hz – 20 kHz |
| Signal‑to‑Noise Ratio | 94 dB |
| Display | 7‑inch WVGA (800×480), 16 M colors, resistive touch |
| Battery | Li‑polymer 4500 mAh |
Hold the Move key, connect the charger, and when the indicator turns orange the device enters the firmware upgrade screen.
Press and hold the Move key while pressing the Power key to launch the touch‑screen calibration interface, then follow the on‑screen prompts.
Open the USB HOST device, insert the wired network card and cable, then configure the IP settings as needed.