Data sheet for the SKUM WAFV-MK2 water actuated foam valve with stainless steel ball valve, actuator pressure range, applications, and ordering information.
This data sheet describes the SKUM Water Actuated Foam Valve (WAFV-MK2), which consists of a ball valve and an approved, corrosion-resistant actuator. The valve operates by water pressure only, from the mains water pressure supply on a bladder tank system or from the water motor alarm port in a fire sprinkler system. The valve body is made from 316 stainless steel and the actuator has an anodized aluminum housing. The actuator opens the valve at a water pressure of 2 bar to 16 bar (29 psi to 232 psi) and must be manually reset; it is fitted with a manual override feature.
The WAFV is primarily used in bladder tank foam systems, installed in the foam concentrate line just before the proportioner. It is also used in foam pump balanced pressure proportioning systems and in non-pressurised tank systems where the proportioner is below the tank, preventing foam leakage or foam siphoning into the water line. The document lists features, connections, listings and approvals, ordering information with part numbers for DN 20 to DN 80 sizes, and performance data with dimensions and weights.
| Valve body material | 316 stainless steel |
|---|---|
| Actuator housing material | Anodized aluminum |
| Actuator opening pressure | 2 bar to 16 bar (29 psi to 232 psi) |
| Maximum actuator operating pressure | 12.1 bar (175 psi) |
| Maximum water or foam pressure through valve | 12.1 bar (175 psi) |
| Working temperature | -30°C to +100°C |
| Listings and approvals | PED, ATEX (zone 1), SIL 3 |
| Connections | Foam: BSP screw threaded or weld end (WE); water actuating line: BSP 1/4 in. |
| Valve sizes | DN 20, DN 40, DN 50, DN 80 |
The actuator must be manually reset: check that the resetting lever is attached and can be mounted on the operating shaft, check that pressure from the water actuating line is relieved, then manually operate the lever to close the valve.
It is recommended that a Pressure Reducing Valve (PRV), PN1327-006, be installed in the actuation line.
It is installed in the foam concentrate line just before the proportioner; increased water pressure opens the WAFV and discharges foam concentrate to the proportioner.
Yes, the document states that a WAFV may be used with all types of foam concentrates.