Simag SVD 152/222/203/303/503 Modular Cuber Service Manual

Service manual for Simag SVD 152/222/203/303/503 electronic modular cubers: specifications, installation, start-up, operation, wiring and cleaning.


Simag SVD 152/222/203/303/503 Modular Cuber Service Manual - cover page
Brand
SIMAG
Category
Refrigerators
Document type
Service Manual
Language
English
Pages
37
File format
PDF
File size
3.4 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
250C26088CB8465E3E8ED7BD8A61D2F9

About this manual

This service manual covers the Simag SVD 152/222 (22 inch model) and SVD 203/303/503 (30 inch model) Electronic Modular Cubers, part number 73000009-00, version A. It gives the specifications for each model, installation requirements for the installer, plumber and electrician, and describes the start-up, freezing and harvest cycles, the water and refrigeration systems during freeze and harvest, control sequence, alarm conditions and PC board set up.

The manual also contains wiring diagrams for SVD 152/222, SVD 203/303, SVD 503 (220V) and SVD 503 (380V), a service diagnosis table of symptoms, possible causes and corrections, and maintenance, cleaning and sanitation instructions for the icemaker, the ice storage bin and the cabinet exterior. Maintenance and cleaning should be scheduled at least two times per year by an authorized Simag service agency.

What's inside

  • Specifications
  • For the Installer
  • Storage Bin
  • Important Operating Requirements
  • Select Location
  • For the Plumber (Water inlet and drains)
  • Electrical Connections
  • Start-up Cycle
  • Freezing Cycle
  • Harvest Cycle

Specifications

RefrigerantR404A / R452A, charge per nameplate rating
Air temperature range10 °C (50 °F) minimum to 40 °C (100 °F) maximum
Water temperature range5 °C (40 °F) to 35 °C (90 °F)
Water pressure1 bar gauge to 5 bar gauge
Electrical voltage variationVoltage rating specified on nameplate, -10% to +10%
Service clearance15 cm minimum left, right and rear for air-cooled models
Standard legs14-17 cm height including adjustable leveling foot
Ice storage binsRB100, RB150, RB190 and RB300
Minimum water electrical conductivityHigher than 20 μs
Ice machine cleaner dose during cleaningSVD 152: 185 cc, SVD 222: 210 cc, SVD 203-303: 250 cc, SVD 503: 350 cc

Frequently asked questions

What air and water temperature limits does the Simag SVD modular cuber require?

Air temperature must be between 10 °C (50 °F) and 40 °C (100 °F), and water temperature between 5 °C (40 °F) and 35 °C (90 °F). Water pressure must be between 1 and 5 bar gauge.

How often should maintenance and cleaning be scheduled?

The manual states that the maintenance and cleaning should be scheduled at least two times per year on the icemaker by an authorized Simag service agency.

Which storage bins can the SVD 152-222-203-303-503 stack onto?

They can stack onto Simag bin models RB100, RB150, RB190 and RB300.

How is the cleaning cycle started on the icemaker?

Wait until the end of the harvest cycle, switch the machine off and on again, then push the CLEAN BUTTON on the LED display for 2-3 seconds within one minute; the red CLEAN LED blinks fast during the procedure.

Download PDF (3.4 MB)