Operator's manual for Sharp Milling Machines VER.3 vertical machining center models SV-4328, SV5128 and SV6332: safety, installation, operation and programming.
This VER.3 Operator's Manual covers the SV-4328, SV5128 and SV6332 vertical machining center. It opens with a safety chapter on safety precautions, warning labels and safety devices, then covers preparations for installation such as the set-up area, transport route, set-up conditions and air/power sources, followed by operation of the main operation panel, LCD control panel, M-codes and machine parameters.
The remaining chapters deal with data registration and editing, workpiece and tool attachment, tool change, cutting fluid supply, chip disposal, automatic operation and program editing, programming commands (G, F, S and T), program input/output through memory cards and the all I/O screen, a cutting tool condition list, a parts manual for the spindle head, column, base, saddle and table, magazine and pneumatic system, and an appendix on replacing the fuse, battery and fan unit and on high speed high accuracy machining control functions.
| Electrical Source | AC200/220V ±10%, 50/60Hz ±2% |
|---|---|
| Maximum Power Consumption (SV4328ST/SX, SV5128ST/SX) | 30 kVA standard, 35 kVA including options |
| Maximum Power Consumption (SV6332SX) | 35 kVA standard, 40 kVA including options |
| Air Source | 0.5 to 0.8 MPa, 660 L/min (ANR) |
| Air Filtration Unit | 5 μm + 0.3 μm + moisture remover |
The manual states that Chapter 1 "SAFETY" must be read and understood before machine operation to ensure safe working conditions.
The manual describes three methods under NC program registration.
An air source of 0.5 to 0.8 MPa with 660 L/min (ANR) is specified, with clean dry air.
In Chapter 2, section 5 "AIR / POWER SOURCE", which specifies AC200/220V ±10% and 50/60Hz ±2%.