Operating instructions for the Selec-Trac transfer case: 2WD/4WD mode selection, HI, N and LO range shifts, and related cautions.
This one-page information sheet describes the functions of the Selec-Trac transfer case and how the mode switch and range lever must be used together. In the HI range the mode switch selects either 2-wheel drive or full-time 4-wheel drive, and the range lever then offers HI, N or LO ranges once 4WD is fully engaged.
The sheet explains when mode and range changes may be made, the towing use of the N (Neutral) position, and the off-road use of LO range. It ends with cautions about engaging LO range, parking in N, driving with the transfer case not fully engaged, and installing selective drive hubs.
| Drive modes in HI range | 2-wheel drive or full-time 4-wheel drive |
|---|---|
| Drive mode in LO range | Part time four-wheel drive |
| Range shift speed | 2-3 mph (3-5 km/h), transmission in neutral |
| Range lever positions | HI, N, LO |
With the range lever in the HI range, move the mode switch to select 2-wheel drive or full-time 4-wheel drive. The selection can be made while the vehicle is moving at any legal speed.
Range shifts must only be made at low speed, 2-3 mph (3-5 km/h), with the transmission shifted to neutral and the transfer case fully engaged in 4WD.
In the N (Neutral) position the axles are disengaged from the powertrain, so the vehicle may be towed without removing the propeller shafts.
Yes. In the HI position with 4WD engaged the vehicle may be operated on all road surfaces, and Selec-Trac 4WD can be used year-round (full time).