Seekfit BeyondStudio Non-Linear Editing Card Edius Plugin Installation and User Guide

Guide for installing the Seekfit BeyondStudio editing card, WDM driver and Edius plugin, and configuring SDI/HDMI/YUV/CVBS capture and playback.


Seekfit BeyondStudio Non-Linear Editing Card Edius Plugin Installation and User Guide - cover page
Brand
Seekfit
Category
Expansion card
Document type
User Manual
Language
Chinese
Pages
9
File format
PDF
File size
745 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
2AF30EA78960DF974FB4E9321B7EAD07

About this manual

The document explains how to install the Seekfit BeyondStudio non-linear editing card in a PCI-E slot and install the required software. It requires administrator rights, covers QuickTime, Edius 7/8/9, the WDM driver, BeyondIO SDK and plugin registration, and notes that Edius versions below 7 do not support the plugin. It also gives BIOS settings for HP, DELL and Supermicro servers when the card is detected but cannot open.

It then describes Edius capture setup using SDI as an example, including project presets, preview device selection, BeyondServer source settings, and selecting the input device. It also covers capturing multiple video sources over SDI, HDMI, YUV, CVBS and analog audio, the board's loop-through output, and playback of local or captured AVI material through the card. This manual is written in Chinese.

What's inside

  • Installation
  • Software installation steps
  • Board driver installation
  • BeyondIO SDK installation
  • Plugin registration
  • Selecting the editing card
  • Edius capture settings
  • Multiple video source capture
  • Board loop-through output
  • Playback

Specifications

SDI input1080I_50 SDI signal
HDMI input1080I_50 HDMI signal
YUV input1080I_50 YUV component signal
CVBS/YUV inputPAL signal
Analog audio inputleft and right RCA channels

Frequently asked questions

Which Edius versions support the plugin?

The guide says to install Edius 7, 8 or 9; Edius versions below 7 do not support the plugin.

What should I change in the BIOS on HP, DELL or Supermicro servers if the card is detected but cannot open?

Set the PCI-E option containing “above4GB” (Memory mapped I/O above 4GB) from enable to disable, save the configuration, and restart the computer.

Where do I select the BeyondStudio card in Edius?

In Edius, open System Settings, then Hardware, then Preview Device, and select the ByStudio editing card.

What happens to loop-through output when the card is playing out?

The card cancels loop-through and outputs the audio and video of the local program being played out.

Download PDF (745 KB)