Installation manual for SEC plate heat exchangers covering principles, construction, transport, installation, piping, flushing and storage.
This manual explains the operating principle of plate heat exchangers (PHE) built from corrugated thin alloy plates with gasket‑sealed channels. It describes the construction details, available plate materials and typical plate thickness.
The guide provides step‑by‑step instructions for transporting, installing, piping, flushing and maintaining the unit, including required clearances, pipe loading limits, and long‑term storage procedures. Contact information for SEC Heat Exchangers services is listed at the end.
| Plate thickness | 0.6‑1.0 mm |
|---|---|
| Minimum clearance | 0.6 m |
| Gasket material | Composed rubber |
| Plate materials | Stainless steel, Titanium, Hastelloy, Copper‑Nickel, Al‑brass |
| Port type (standard) | Alloy‑clad studded port with elastomeric liners |
A minimum clearance of 0.6 m on each side of the heat exchanger is required to allow removal of the plate pack.
Before first operation, flush the piping to remove all foreign material such as sand or welding slag; failure to do so may void the warranty and affect heat‑transfer rates.
Each plate can have up to four connection holes for fluid transfer, with gaskets fitted to confine the liquids.