Schlage F-Series, A-Series, S-Series, and B-Series Locks Rekeying Manual

About this manual

This manual provides detailed instructions for rekeying various Schlage lock products, including F-Series compressible cylinder knobs and levers, A-Series and Contractor Series standard usage knobs, S-Series and Contractor Series heavy usage knobs, and B-Series deadbolts. It covers the use of Keying Kits 40-132 and 40-134 to replace bottom pins, top pins, and springs in the lock cylinders.

What's inside

• Rekeying F-Series Compressible Cylinder Knobs and Levers
• Rekeying A-Series and Contractor Series Standard Usage Knobs
• Rekeying S-Series and Contractor Series Heavy Usage Knobs
• Rekeying B-Series Deadbolts
• Using Key Gauge/Reinserting Disengaged Pins & Springs
• Cylinder Removal and Reassembly
• Cylinder Repinning Method 1
• Cylinder Repinning Method 2
• Glossary of Terms

Specifications

Frequently asked questions

What keying kits are required for rekeying these locks?

The manual specifies the use of Keying Kits 40-132 and 40-134 for rekeying the covered lock series.

How much force is needed to remove the cylinder from the knob?

No more than 5 pounds of force is required to push the cylinder out of the back of the knob.

Are there different methods for repinning the cylinder?

Yes, the manual describes two methods: one recommended for compressible cylinders and another involving removing the steel cap.