User manual for the SC-1 16x DVD Dual optical drive covering safety, installation, software setup, features and troubleshooting.
This manual provides safety warnings, hardware installation steps, system requirements and detailed wiring instructions for the SC-1 16x DVD Dual optical drive. It also explains the drive's supported disc formats, performance specifications and the included software suite.
The document includes a section on the latest features such as Auto Balance System, Dynamic Damping, Noise Control, JustLink buffer‑underrun protection, and provides a comprehensive FAQ for common installation and operation problems. This manual is written in Chinese.
| Maximum DVD+R DL capacity | 8.5 GB |
|---|---|
| UDMA mode | Mode 4 (66 MB/sec) |
| DVD+R write speed | 16× |
| CD read speed | 40× |
| Supported disc formats | All major CD/DVD formats (DVD±RW/±R, CD‑R, CD‑RW, Video CD, etc.) |
Check that the computer is powered off and unplugged, verify each IDE cable connector for bent pins or mis‑connection, and ensure all power connectors are securely attached. Also confirm the master/slave jumper settings if the drive shares an IDE channel.
Restart the computer or power‑cycle it, verify the drive’s power by pressing the eject button, ensure the IDE cable is properly connected with the red wire aligned to pin‑1, and enable both IDE channels in the BIOS.
Make sure the disc is inserted with the label side up, wait a moment for the drive to recognize it, and confirm that the disc is not blank. If the problem persists, try the disc in another drive to rule out a disc issue.