SBIG Remote Guide Head installation instructions for using the external cooled guiding CCD with STL and newer ST series cameras.
The SBIG Remote Guide Head is an optional accessory for STL and newer ST series cameras that allows self-guiding with the guider external to the camera and filter wheel. It contains a cooled TC-237H guiding CCD with 657 x 495 pixels at 7.4 microns, uses a 16-bit A/D, draws power from the main camera, and is controlled by the same software as the internal guider.
The head can be used with a separate guide scope using the supplied 1.25-inch nosepiece, optional camera lens adapters, or an optional off-axis guider. In CCDOPS, the active tracking CCD can be selected as Internal or External, and the TE cooling of the Remote Head is automatic when cooling to the imaging CCD is enabled.
| Guiding CCD | Cooled TC-237H |
|---|---|
| Pixel array | 657 x 495 pixels |
| Pixel size | 7.4 microns |
| A/D converter | 16-bit |
| Nosepiece | Supplied 1.25-inch nosepiece |
| Backfocus compatibility | eFinder, C-mount lenses, and CLA-5 adapter for Nikon and Canon FD lenses |
| Mounting threads | Standard 1/4-20 tripod threads |
| Desiccant plug baking | About 4 hours at 350-400°F (200°C) |
Yes, the same Remote Guide Head works with any STL or ST model camera equipped with a Remote Guide Head port.
Go to Camera -> Setup -> Tracking CCD and then select External.
No, it draws its power from the main camera.
Unscrew the desiccant plug, remove the small o-ring, and bake the plug in a conventional oven for about 4 hours at 350-400°F (200°C).