Ruvati installation guide for undermount granite composite sinks: countertop cutout, mounting clips, reveal options, care and lifetime warranty.
This two-page Ruvati document is an installation guide for undermount granite composite kitchen sinks. It lists the model numbers covered (RVG1650, RVG2016, RVG2018, RVG2022, RVG2023, RVG2027, RVG2030, RVG2033, RVG2080, RVG2302, RVG2306, RVG2310, RVG2321, RVG2325, RVG2327, RVG2385 and RVG2388) and gives step-by-step instructions for cutting the countertop opening, drilling anchor holes, applying silicone caulk and fastening the sink with mounting clips. It also explains the three countertop edge options: a 1/4" reveal (recommended), a flush fit, and an overhang, which the guide says should not be used.
The guide closes with care and maintenance advice — regular cleaning with normal detergent and warm water, weekly cleaning with a non-abrasive cleanser, and removal of hard water stains with vinegar — plus warnings against bleach solutions and steel wool pads. It also states that Ruvati sinks carry a limited lifetime warranty for residential use, lists the conditions for a claim, and notes that accessories such as rinse grids, cutting boards and strainers are not covered.
| Mounting clips for longer sides | 3 mounting clips recommended for sides 20" or longer |
|---|---|
| Mounting clips for shorter sides | 2 mounting clips |
| Anchor drill bit | 3/8" drill bit with a 1/2" depth stop |
| Recommended reveal | 1/4" reveal (countertop edge approximately 1/4" back from sink edge) |
Clean regularly with normal detergent and warm water, dry and buff with a soft cloth after use, and clean once a week with a non-abrasive cleanser such as dish soap and a soft sponge.
No. The sink can be installed with a 1/4" reveal or a flush fit, and Ruvati recommends the 1/4" reveal; it should not be installed with an overhang.
Ruvati sinks carry a limited lifetime warranty for residential use, subject to conditions such as including valid proof of purchase; accessories, strainers and rinse grids are not covered.
Light scratches can be removed by polishing with a mild abrasive pad such as 3M Maroon or Green pad or low-grit sandpaper; for stubborn hard water stains, use straight or 50% vinegar solution for one hour, then scrub and rinse.