Installation instructions for RIS VSL Series light fixtures, covering safety notes, needed tools, wiring to the junction box and CCT color temperature…
This two-page document gives the installation instructions for RIS VSL Series light fixtures, printed with the document number RIS10026 and the address 773 S. Benson Ave. Ontario, CA 91762 USA. It lists the tools needed for the job, the hardware supplied with the fixture, and the four installation steps from removing the mounting bracket to securing the fixture base.
The second page explains the color temperature adjustment: CCT switches on each board are set to the desired color temperature, all boards must be set the same way, and the fixture is preset to 3000K from the factory. Safety instructions and important safe practices are included, such as having all wiring done by a qualified electrician and turning power off before adjusting the CCT switches.
| Supply voltage | 120V AC fused circuit |
|---|---|
| Dimming | Can be used on a dimming circuit |
| Factory CCT preset | 3000K |
| Selectable color temperatures | 2700K, 3000K, 3500K, 4000K, 5000K |
| Wire connectors supplied | 3 pcs |
| Mounting screws supplied | 2 pcs |
| Minimum supply conductors | 90°C |
The fixture is preset to 3000K from the factory. The CCT switches can be adjusted to 2700K, 3000K, 3500K, 4000K or 5000K.
It is designed for use in a 120V AC fused circuit and can also be used on a dimming circuit.
Yes, the instructions state that the fixture can be used on a dimming circuit.
Power to the fixture must always be turned off before adjusting the CCT switches, and all boards must be set the same way.