RIGOL DS4000E Series Digital Oscilloscope Quick Guide

Quick guide for the RIGOL DS4000E series digital oscilloscope covering safety, first-time setup, probe connection, probe compensation and remote control.


RIGOL DS4000E Series Digital Oscilloscope Quick Guide - cover page
Brand
Rigol
Category
Other Electronics
Document type
Quick Start Guide
Language
English
Pages
36
File format
PDF
File size
1.4 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
55B93E4D93313660A45E6A3392E269FF

About this manual

This Quick Guide from RIGOL introduces the basic information needed when using the DS4000E series digital oscilloscope for the first time. It covers the guaranty and declaration, general safety summary, safety notices and symbols, care and cleaning, and a document overview with format conventions.

The guide describes general inspection of the packaging, instrument and accessories, gives an overview of the front panel, rear panel and user interface, and explains how to prepare the oscilloscope for use: removing the front panel cover, connecting the power supply, power-on inspection, connecting the probe, function inspection for the passive probe, probe compensation, using the built-in help system and remote control. It also points to the RIGOL website (www.rigol.com) for more product information and the latest manuals.

What's inside

  • Guaranty and Declaration
  • General Safety Summary
  • Safety Notices and Symbols
  • Care and Cleaning
  • Document Overview
  • General Inspection
  • Product Overview
  • To Prepare the Oscilloscope for Use
  • Function Inspection for the Passive Probe
  • Probe Compensation

Specifications

DS4024E analog bandwidth200 MHz
DS4024E analog channels4
DS4014E analog bandwidth100 MHz
DS4014E analog channels4
AC power input100 V-127 V, 45 Hz-440 Hz or 100 V-240 V, 45 Hz-65 Hz

Frequently asked questions

How do I perform probe compensation on the DS4000E?

Restore factory settings with the Default key, connect the probe between CH1 and the probe compensation signal output terminal, press AUTO, then adjust the low-frequency compensation adjustment hole on the probe with a non-metallic screwdriver until the displayed square wave is correctly compensated.

How do I check the function of the passive probe before measurement?

Restore the oscilloscope to factory settings, connect the probe's ground alligator clip to the ground terminal and the probe tip to the probe compensation signal output terminal on CH1, then press AUTO and observe that a square wave is displayed.

How do I restore the oscilloscope to factory settings?

Press the Default key and then the OK/confirm key to restore the oscilloscope to factory settings.

Can the probe compensation signal be used for calibration?

No, the probe compensation signal is only for probe compensation adjustment and must not be used for calibration.

Download PDF (1.4 MB)

More Rigol Manuals


View all Rigol manuals →