Rhino RCF™ Structural Epoxy Injection Resin Kit Instructions

About this manual

This document provides step-by-step instructions for using the Rhino RCF™ Structural Epoxy Injection Resin Kit. The kit includes structural epoxy injection resin, high strength anchoring epoxy paste, ports, mixing nozzles, and safety equipment. It is designed for repairing cracks in foundation walls and other concrete structures.

What's inside

• What Comes In The Kit
• Safety Warnings
• Preparation
• Port Locations
• Port Installation
• Covering The Crack
• Injection Clean Up

Frequently asked questions

What tools are required to remove the ports from the wall after the epoxy has cured?

You must use a hammer to remove the ports from the wall once the epoxy and resin have cured.

How far should the epoxy be feathered on both sides of the crack?

You should feather the epoxy approximately 2 inches or more on both sides of the crack.

How far apart should port locations be marked for continuous cracks?

For continuous cracks, you should mark port locations approximately every 18 inches starting from the bottom of the crack.