Regal Rexnord EM Replacement Control Module Kit Installation Guide

Installation guide for Regal Rexnord EM Replacement Control Module Kit compatible with Genteq® X13, Endura® Pro and Evergreen EM motors.


Regal Rexnord EM Replacement Control Module Kit Installation Guide - cover page
Brand
Regal Rexnord
Category
Industrial Robot
Document type
Installation Guide
Language
Chinese
Pages
4
File format
PDF
File size
560 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
5D7617C78480B7AA803A3167192AB5A1

About this manual

This guide provides step-by-step instructions for replacing control modules in compatible motors. It includes safety warnings, installation procedures, diagnostic tests, and troubleshooting for rotation issues. The kit includes the control module, mounting bolts, and optional low voltage harness. Proper voltage and horsepower matching are required for safe installation.

The guide also covers motor diagnostics, rotation sensing, and how to reverse motor direction if needed. Safety precautions include disconnecting power before installation and using qualified technicians. The document is updated as of June 2022 and includes contact information for customer support. This manual is written in Chinese.

What's inside

  • Control Module Removal
  • Control Module Installation
  • Motor Module Diagnostics
  • Rotation Sensing
  • Troubleshooting
  • Changing Motor Rotation

Specifications

Allowable Voltage Range115 VAC models (90-132 VAC), 208-230 VAC models (180-264 VAC)
RPM1075
Speeds5 (24 VAC inputs) 3 (24 VDC inputs) PWM (600-1200 RPM range)
RotationDual - Auto Rotation Sensing
Ambient Rating1/3 & 1/2 HP models (-20 to 65°C), 3/4 & 1 HP models (-20 to 45°C)

Frequently asked questions

What motors is this control module compatible with?

It can replace ECM control modules in Genteq® X13, Endura® Pro, and Evergreen EM motors.

What should I check before installing the new control module?

Match the horsepower (HP) and voltage (VAC) ratings of the new control to the one being replaced. RPM and amperage do not need to match.

How do I change the motor’s rotation direction?

Disconnect all 24 VAC speed taps, connect terminals 1, 3, and 5 to a 24 VAC power source, power on, wait 5 minutes, then reconnect the speed taps and power on again.

Download PDF (560 KB)

More Regal Rexnord Manuals


View all Regal Rexnord manuals →