User manual for the Qingchuan QC86H digital two-phase stepper driver, covering installation, wiring, DIP switch settings, LED indications and troubleshooting.
Qingchuan QC86H is a digital two-phase stepper driver made by Qingchuan Intelligent Technology (Suzhou) Co., Ltd. The manual introduces the QC series, which uses a 32-bit DSP, PID current control, built-in microstepping and power-on parameter auto-tuning.
It explains the installation environment and mounting requirements, power and motor wiring, control signal connections, DIP switch settings for current and pulses per revolution, LED status indications and common troubleshooting. It also lists warranty terms and covers 4-, 6- and 8-wire two-phase stepper motor connections. This manual is written in Chinese.
| Supply voltage | 20–80 VAC / 24–100 VDC |
|---|---|
| Maximum output current | 7.2 A peak |
| Current control | PID current control algorithm |
| Microstep settings | DIP switch, 16 options |
| Maximum speed | Up to 3000 rpm with a suitable stepper motor |
| Pulse filter | 2 MHz digital signal filter |
| Operating temperature / humidity | 0 to 45 °C / ≤90% RH, no condensation |
| Ingress protection | IP54 |
| Vibration | 0.5 G (4.9 m/s²) max |
The QC86H accepts 20–80 VAC or 24–100 VDC.
No. The manual explicitly warns against connecting the driver directly to 220 VAC mains.
They set the number of pulses required per motor revolution.
It indicates overcurrent in the driver.