Installation and maintenance instructions for the PAL PCR-1Z Class 2 outdoor LED pool light controller, including wiring, DIP settings, and remote coding.
The PCR-1Z is a UL Listed Class 2 power supply and outdoor driver/receiver designed to supply 24V DC to PAL 4 Wire UL Listed LED pool lights. It has an IP65 weatherproof enclosure, must be installed in accordance with the National Electrical Code by a certified electrician or qualified pool technician, and must be mounted at least 5 feet horizontally from the inside pool wall and not less than 1 foot above the maximum water level.
Installation instructions cover knockout removal, mounting with the enclosure legs and supplied screws, connecting a 100-120V supply, and wiring up to two PAL 4 wire lights through the output conduit entries. The controller is factory set to operate with the PCZ-2 hand-held transmitter and includes DIP switch/clone settings for Jandy, Pentair, Hayward, PAL, and Astral modes, code matching and clearing, mode selection, brightness settings, and optional Wi-Fi control from Apple iOS devices.
| Power supply type | UL Listed Class 2 Power Supply |
|---|---|
| Output voltage | Constant 24V DC |
| Enclosure rating | IP65 wet location |
| Light outputs | Up to 2 PAL 4-wire LED pool lights |
| Minimum distance from pool wall | 5 feet horizontally |
| Minimum height above maximum water level | 1 foot to top of enclosure |
| Maximum transmitters per receiver | 4 |
| Brightness settings | 100%, 80%, 60%, 40%, 20% |
| Wattage | 16/35/65 W |
It is designed to supply 24V DC to PAL 4 Wire UL Listed LED pool lights.
The enclosure has output conduit entries for up to two PAL 4-wire LED pool lights.
It must be at least 5 feet horizontally from the inside pool wall and not less than 1 foot above the maximum water level, measured to the top of the enclosure.
A single PCR-1Z can be controlled by a maximum of four PCZ-2 transmitters.