OSO Unvented Hot Water Cylinder Installation Manual

Installation manual for OSO unvented hot water cylinders covering siting, pipework, commissioning, safety and maintenance.


OSO Unvented Hot Water Cylinder Installation Manual - cover page
Brand
OSO
Category
Water heater
Document type
Installation Guide
Language
English
Pages
16
File format
PDF
File size
751 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
26BDF951AF6F5F78C8DA9CA1E412EB13

About this manual

This manual provides installation details for OSO unvented hot water cylinders. It covers component identification, cold water supply and hot water outlet connections, filling, draining, commissioning, safety cut-out operation, and maintenance of the Multibloc control valve.

It also includes dimension and weight information, tundish and discharge pipe requirements, and notes on compliance with legislation and codes of practice.

What's inside

  • Installation details
  • General Layout
  • Cold Water Supply
  • Hot Water Supply
  • Discharge Pipe
  • Filling up
  • Safety Cut-out
  • Cold water inlet control (Multibloc)
  • Tundish
  • Maintenance

Specifications

Supply pressureUp to 16 bar
Pressure reducing valve setting2.1 bar
Expansion relief valve setting8.0 bar
Tundish maximum distance from relief valve drain500 mm
Tundish pipework minimum vertical length300 mm
Maximum length of 22 mm discharge pipework9 m
Bend equivalent length0.8 m per bend or elbow
Cold water supply pipe size22 mm nominal
Tundish pipework size22 mm

Frequently asked questions

What supply pressure is the OSO unvented unit designed for?

It is designed for supply pressures up to 16 bar; for pressures over 16 bar, an additional pressure reducing valve must be fitted.

How far from the relief valve drain connection can the tundish be installed?

The tundish must be installed within a maximum of 500 mm from that connection.

What should be done if hot water discharges from the tundish?

Turn off the electrical supply to the immersion heater, isolate an indirect unit from the boiler, and contact the installer or competent engineer.

Does the Multibloc control valve need routine maintenance?

Under normal circumstances it should not require maintenance, but annual inspection and/or cleaning may be necessary depending on local water conditions.

Download PDF (751 KB)